|
| |
TM 9-2320-364-20-5
15-58
15-20. SELF-GUIDED COUPLER REPAIR (CONT).
(12)
Install lube fitting (10) in screw (8).
(13)
Install lube fitting cover (9) on lube fitting
(10).
(14)
Install coupler jaw (5) on coupler (2) using
screw (8) and nut (7).
NOTE
Nut in Step (15) is properly
installed when coupler jaw can
rotate freely.
(15)
Tighten nut (7) on screw (8) until nut (7)
contacts coupler (2).
(16)
Back off nut (7) to nearest slot and install
cotter pin (6).
e.
Installation.
Ensure sleeve is fully supported
until after Step (2) is completed
or sleeve may fall. Failure to
comply may result in damage to
parts.
(1)
With the aid of an assistant, position sleeve
(7) on truck (11).
(2)
With the aid of an assistant, install four
screws (10), washers (9) and nuts (8) in
sleeve (7). Tighten nut to 500 lb-ft (678
N.m).
5
7
2
8
10
9
6
|
