|
| |
TM 9-2320-364-20-5
17-16
17-8. CAB DOOR AND HINGE REPLACEMENT (CONT).
b.
Installation.
NOTE
Procedure is identical for
both doors. Left door is
shown.
Nut strip can fall into door
jam during installation.
Locknut and nut strip are
installed through cut out on
backs side of door frame in
cab.
(1)
Install dovetail guide (15) and nut strip (14)
on cab assembly (5) with two screws (13).
(2)
Install striker pin (18) and washer (17) on
cab assembly (5) with locknut (16).
Adhesives, solvents, and sealing
compounds can burn easily, can
give off harmful vapors, and are
harmful to skin and clothing. To
avoid injury or death, keep away
from open fire and use in well-
ventilated area. If adhesive,
solvent, or sealing compound
gets on skin or clothing, wash
immediately with soap and
water.
(3)
Apply sealing compound in corners of cab
door opening.
(4)
Install door seal (12) on cab assembly (5).
(5)
Install door seal bracket (11) on cab
assembly (5) with three self-tapping
screws (10).
|
