|
| |
TM 9-2320-364-20-5
17-47
Adhesives, solvents, and sealing compounds can burn easily, can give off harmful vapors, and
are harmful to skin and clothing. To avoid injury or death, keep away from open fire and use in
well-ventilated area. If adhesive, solvent, or sealing compound gets on skin or clothing, wash
immediately with soap and water.
Use insulation adhesive on all panels that are installed inside cab. Use adhesive on panels that
are installed under floor. Using wrong adhesive will cause premature failure.
Ensure that cab shell is free of old adhesive, insulation, dirt, and grease. Dirty surface will
cause premature failure.
NOTE
Ensure that adhesive is applied to side of insulation panel that contacts cab shell.
Ensure that floor insulation is installed under cab shell.
(2)
Coat insulation panel (3) with adhesive.
(3)
Position insulation panel (3) on cab shell (4).
(4)
Press insulation panel (3) uniformly over
entire surface.
NOTE
If original insulation panel had
retaining strip, perform Step (5).
If not, go to e. Follow-On
Maintenance.
(5)
Install four retaining strips (2) on insulation
panel (3) and secure with eight screws (1)
into cab shell (4).
|
