|
| |
TM 9-2320-364-20-5
17-89
b.
Installation.
Adhesives, solvents, and sealing compounds can burn easily, can give off harmful vapors, and
are harmful to skin and clothing. To avoid injury or death, keep away from open fire and use
in well-ventilated area. If adhesive, solvent, or sealing compound gets on skin or clothing,
wash immediately with soap and water.
NOTE
Perform Steps (1) and (2) if
rubber channel was removed.
(1)
Apply primer to rubber channel ends (8).
(2)
Apply adhesive to rubber channel ends (8)
and install rubber channel in cab (7).
(3)
Apply soap solution to rubber channel (8).
(4)
Install peep window (6) in rubber
channel (8).
NOTE
Ensure ends of rubber channel
are not in same position as ends
of windshield seal locking strip
or leakage may occur.
(5)
Apply soap solution to rubber channel (8)
and install windshield seal locking strip (5)
over peep window (6) on rubber channel.
(6)
Apply primer to ends of windshield seal
locking strip (5).
(7)
Apply adhesive to ends of windshield seal
locking strip (5) and secure in place.
(8)
Install bar (3) on skid plate (4) with two
lockwashers (2) and screws (1).
c.
Follow-On Maintenance:
Remove wheel chocks, (TM 9-2320-364-10).
END OF TASK
|
