|
| |
TM 9-2320-364-20-5
17-90
Materials/Parts
Locknut (26) (Item 106, Appendix F)
This task covers:
a. Removal
b. Installation
c. Follow-On Maintenance
INITIAL SETUP
Personnel Required
Two
Equipment Condition
Engine OFF, (TM 9-2320-364-10)
Wheels chocked, (TM 9-2320-364-10)
Tools and Special Tools
Tool Kit, General Mechanic’s: Automotive
(Item 74, Appendix G)
17-32. RUBBER FENDER EDGING REPLACEMENT.
a.
Removal.
NOTE
Both rubber fender edgings are removed the same way, right side shown.
(1)
Remove two locknuts (1), screws (2) and bracket (3) from right fender (4). Discard locknuts.
(2)
With the aid of an assistant remove 24 locknuts (5), screws (6), two strips (7), and rubber fender edging (8)
from right fender (4). Discard locknuts.
b.
Installation.
(1)
With the aid of an assistant, position rubber fender edging (8) on right fender (4) with two strips (7) and 24
screws (6) and locknuts (5).
(2)
Install bracket (3) on right fender (4) with two screws (2) and locknuts (1).
(3)
Tighten 24 locknuts (5) on screws (6).
c.
Follow-On Maintenance:
Remove wheel chocks, (TM 9-2320-364-10).
END OF TASK
|
