|
| |
TM 9-2320-364-20-5
18-25
(8)
Remove two screws (30) and wear pad (31)
from bracket assembly (15).
(9)
Remove two screws (32), lockwashers (33),
weld pin (34), four thrust washers (35) and
two roller assemblies (36) from bracket
assembly (15). Discard lockwashers.
Do not inhale fumes; could cause
severe injury or death.
NOTE
It will be necessary to heat the
screw with a propane torch to
remove the screw.
(10)
Remove hex socket screw (37) from bar
assembly (21).
b.
Installation.
Adhesives, solvents, and sealing compounds can burn easily, can give off harmful vapors,
and are harmful to skin and clothing. To avoid injury or death, keep away from open fire
and use in well-ventilated area. If adhesive, solvent, or sealing compound gets on skin or
clothing, wash immediately with soap and water.
(1)
Coat hex socket screw (37) with sealing compound.
(2)
Install hex socket screw (37) in bar assembly (21). Torque screw to 15 lb-ft (20 N.m).
(3)
Install two roller assemblies (36), four thrust washers (35) and weld pin (34) in bracket assembly (15).
(4)
Coat two screws (32) with sealing compound.
(5)
Install two lockwashers (33) and screws (32) in bracket assembly (15). Torque screw to 12 lb-ft (20 N.m).
(6)
Coat two screws (30) with sealing compound.
(7)
Install wear pad (31) on bracket assembly (15) with two screws (30).
|
