|
| |
TM 9-2320-364-20-5
18-26
18-6. RETAINER BAR/ROLLER REPLACEMENT (CONT).
Adhesives, solvents, and sealing compounds can burn easily, can give off harmful vapors, and
are harmful to skin and clothing. To avoid injury or death, keep away from open fire and use
in well-ventilated area. If adhesive, solvent, or sealing compound gets on skin or clothing,
wash immediately with soap and water.
(8)
Coat four screws (27) with sealing compound.
(9)
Position plates (16) and (17) with four lockwashers (28) and screws (27) on hoist assembly (29).
(10)
Install sensor (26) and sensor bracket (25) to plate (16) with two lockwashers (23), washers (24) and
screws (22). Tighten screws to 16 lb-ft (22 N.m).
(11)
Coat four screws (18) with sealing compound.
(12)
Position bar assembly (21) on plates (16) and (17) with four lockwashers (19), washers (20) and
screws (18).
(13)
Tighten four screws (27) on plates (16) and (17) to 68 lb-ft (91 N.m).
(14)
Adjust gap between bar assembly (21) and drum flange (38) to .06 in. (1.52 mm). Tighten four screws
(18) to 30 lb-ft (41 N.m).
|
