|
| |
TM 9-2320-364-20-5
18-29
b.
Installation.
Adhesives, solvents, and sealing
compounds can burn easily, can
give off harmful vapors, and are
harmful to skin and clothing. To
avoid injury or death, keep away
from open fire and use in a well-
ventilated area. If adhesive,
solvent, or sealing compound
gets on skin or clothing, wash
immediately with soap and water.
NOTE
Perform Step (1) and (2) if
bearing was removed.
Remove any excess adhesive
from outer surfaces of
bearing.
(1)
Apply adhesive between surfaces of
bearing (7) and pointer (2).
(2)
Install bearing (7) in pointer (2).
NOTE
Ensure pointer rotates freely after
installed.
(3)
Install screw (3), two washers (6) and nut (5)
in bearing (7).
(4)
Apply sealing compound to exposed threads
on end of screw (3).
(5)
Install pointer (2) with screw (3) on
crane (4). Tighten screw to 108 lb-in
(12 N.m).
(6)
Install cap plug (1) on pointer (2).
c.
Follow-On Maintenance:
Remove wheel chocks, (TM 9-2320-364-10).
END OF TASK
|
