| |
TM 9-2320-364-20-5
21-101
(10)
Position sensor plate (9) with two clamps
on hook arm (15) as shown.
(11)
Mark line around sensor plate (9) on hook
arm (15).
(12)
Remove two clamps and sensor plate (9)
from hook arm (15).
Adhesives, solvents, and sealing
compounds can burn easily, can
give off harmful vapors, and are
harmful to skin and clothing. To
avoid injury or death, keep away
from open fire and use in
well-ventilated area. If adhesive,
solvent, or sealing compound gets
on skin or clothing, wash
immediately with soap and water.
NOTE
Mix epoxy according to directions
on package.
(13)
Mix epoxy and apply to sensor plate (9) and
hook arm (15).
NOTE
Epoxy takes approximately 15
minutes to cure.
(14)
Clamp sensor plate (9) to hook arm (15) in
position marked until cured.
(15)
Remove clamps from hook arm (15).
(16)
Prime and paint area as necessary. (TM
43-0139).
9
15
CLAMPS
|