|
| |
TM 9-2320-364-20-5
21-119
d.
Assembly.
Keep all moisture and oils off
lamp. Do not touch lamp with
bare hands. Use a clean dry, oil
free cloth to hold lamp while
installing lamp in blackout light.
NOTE
There are two blackout lights.
Both blackout lights are
installed the same way.
Install cable ties as required.
Install ground wire as noted
prior to removal.
(1)
Install gasket (11), blackout light assembly
(10), two screws (7), ground wire (9) and
two locknuts (8) on rear light bar assembly
(12).
Corrosion inhibitor contains
alkali. Do not get in eyes; wear
goggles/safety glasses when
using. Avoid contact with skin.
In case of contact, immediately
wash area with soap and water. If
eyes are contacted, flush eyes
with large amounts of water for at
least 15 minutes and get
immediate medical attention.
(2)
Apply anti-corrosion inhibitor silicone
compound to inside of lamp socket (6).
(3)
Install blackout lamp (5) in blackout lamp
socket (6).
(4)
Install lens cover (4) with two screws (3) in
blackout light assembly (10).
(5)
Connect wire 1680 (1) to wire 490 (2).
(6)
Apply corrosive preventive compound to
ground wire (9).
1
2
4
3
5
6
7
8
10
11
12
9
|
