|
| |
TM 9-2320-364-20-5
21-157
(17)
Install slider arm, (Para 21-31).
(18)
Install slider, (Para 21-29).
c.
Adjustment.
NOTE
Both stow plates and wire ropes
are adjusted the same way. Right
side shown.
(1)
Remove quick release pin (1) and pin (2)
from short strut (3).
NOTE
Stow plate should be
positioned in center of short
strut.
Ensure slider arm is fully
stowed and slider arm handle
contacts long strut prior to
tightening screws.
(2)
Position short strut (3) on stow plate (4) in
stowed position and that handle of arm
assembly (5) contacts long strut (6).
(3)
Tighten two screws (7) and locknuts (8) on
stow plate (4).
(4)
Ensure wire rope (9) is tight.
d.
Follow-on Maintenance:
Install angled roller, (Para 15-16)
Install horizontal roller, (Para 15-15)
Install rear splash guard, (Para 17-39)
Install light bar and brackets, (Para 21-27)
Install hard lift strut, (Para 15-8)
Remove wheel chocks, (TM 9-2320-364-10).
END OF TASK
SLIDERS SHOWN
REMOVED FOR
CLARITY
5
6
1
2
3
4
8
7
9
|
