|
| |
TM 9-2320-364-20-5
21-173
f.
Adjustment.
(1)
Position lifting frame (1) in stow mode
(TM 9-2320-364-10).
(2)
Start engine (TM 9-2320-364-10).
Engine speed must be at idle
before using hydraulic selector
switch, or damage to equipment
may result.
(3)
Set hydraulic selector switch (2) to AUTO
and stow LHS (TM 9-2320-364-10).
(4)
Extend LHS (3) to lifting frame (1).
(5)
Position lifting frame (1) on truck with LHS
in stow mode (TM 9-2320-364-10).
NOTE
Lifting frame is properly stowed
when completely seated on cone
weldment.
(6)
Ensure lifting frame (1) is completely seated
on cone weldment (4).
NOTE
Perform Steps (7) and (8), as
necessary, if lifting frame is not
completely seated.
(7)
Raise lifting frame (1) with LHS (3)
approximately 12 in. (30 cm) then lower
lifting frame on cone weldment (4).
(8)
Repeat Step (6).
(9)
Shut OFF engine.
NOTE
Ensure lifting frame wear pads
contact LHS hook arm.
(10)
With the aid of an assistant, position lifting
frame (1) towards rear of truck until lifting
frame wear pads (5) contact LHS.
2
1
3
STEERING WHEEL
SHOWN REMOVED
FOR CLARITY
3
1
4
5
|
