|
| |
TM 9-2320-364-20-5
21-221
b.
Installation.
Stow cone weldment weighs
approximately 225 lbs (102 kg).
Attach suitable lifting device to
prevent possible injury to
personnel.
NOTE
Install shims as noted prior to
removal.
(1)
Position shim(s) (5) and stow weldment (1)
on front support assembly (4).
NOTE
Screws and locknuts will be
tightened in c. Adjustment
procedures.
(2)
Position six screws (3) and locknuts (2) on
stow weldment (1) and front support
assembly (4).
c.
Adjustment.
NOTE
Measurements should be
taken on both sides of stow
cone weldment.
If measurement “A” is not
18.1 in. (46 cm) 0.125 in.
(3.18 mm), perform Steps (3)
and (6).
If measurement “A” is 18.1
in. (46 cm) 0.125 in. (3.18
mm), go to Step (2).
Stow cone weldment shims
are already installed. Remove
shims as required.
(1)
Measure distance between base of stow
cone weldment (1) and bottom of pivot pin
(2). Record as measurement “A”.
2
3
1
5
4
2
1
A
|
