|
| |
TM 9-2320-364-34-2
12-35
(2)
Remove two locknuts (6), screws (7) and center bearing bracket (8) from bracket (9). Discard locknuts.
(3)
Remove locknut (1), screw (2), steering
shaft (10) and key (4) from gear reducer (5).
Discard locknut and key.
(4)
Remove steering shaft (10) from truck (11).
(5)
Position drain pan under gear reducer (5).
NOTE
Save three screws and washers
for gear reducer installation.
(6)
Remove three locknuts (12), screws (13),
washers (14) and gear reducer (5) from
frame (15). Discard locknuts.
NOTE
If bearing has nicks, burrs,
scratches or dents, perform
Step (7) to replace bearing.
(7)
Remove center bearing (16) from steering
shaft (10). Discard bearing.
b.
Installation.
NOTE
If center bearing was removed,
perform Step (1).
(1)
Install center bearing (16) on steering
shaft (10).
|
