|
| |
TM 9-2320-364-34-2
12-45
(8)
At right front of suspension beam hanger, hold plumb-bob from inside machined surface of suspension
beam hanger straight down to floor and scribe mark on floor.
(9)
At right rear of suspension beam hanger, hold plumb-bob from inside machined surface of suspension
beam hanger straight down to floor and scribe mark on floor.
(10)
Repeat Steps (5) through (9) for left side of Axle No. 3 and suspension beam hanger.
(11)
Distance C (left side) measurement plus 3/8 in. (9.5 mm) should equal the distance D (right side)
measurement within a tolerance of 1/8 in. (3.18 mm) for Axle No. 3.
(12)
If distance between C and D is not equal within tolerances, add or subtract spacers on lateral torque rods,
(Para 14-8).
(13)
If spacers are added or subtracted, it will be necessary to repeat Steps (1) through (12) to verify
measurements.
|
