|
| |
TM 9-2320-364-34-2
12-46
12-8. STEERING SYSTEM ALIGNMENT AND ADJUSTMENT (CONT).
(14)
Repeat Steps (5) through (10) for Axle No. 4.
(15)
Distance E (left side) measurement plus 3/8 in. (9.5 mm) should equal distance F within a tolerance of
1/8 in. (3.18 mm) for Axle No. 4.
(16)
If distance between E and F is not equal within tolerances, add or subtract spacers on lateral torque rods,
(Para 14-8).
(17)
If spacers are added or subtracted, it will be necessary to repeat Steps (14) through (16) to verify
measurements.
(18)
Repeat Steps (5) through (10) for Axle No. 5.
(19)
Distance G (left side) measurement plus 1 1/8 in. (28.5 mm) should equal distance H within a tolerance
of 1/8 in. (3.18 mm) for Axle No. 5.
(20)
If distance between G and H is not equal within tolerances, add or subtract spacers on lateral torque rods,
(Para 14-8).
(21)
If spacers are added or subtracted, it will be necessary to repeat Steps (18) through (20) to verify
measurements.
|
