|
| |
TM 9-2320-364-34-2
3-59
b.
Installation.
Adhesives, solvents, and sealing compounds can burn easily, can give off harmful vapors, and
are harmful to skin and clothing. To avoid injury or death, keep away from open fire and use
in well-ventilated area. If adhesive, solvent, or sealing compound gets on skin or clothing,
wash immediately with soap and water.
NOTE
There is one lifting bracket located on each cylinder head.
Oil filler bracket is located on left side only.
Perform Steps (1) through (12) for left engine lifting bracket only.
(1)
Apply primer and sealing compound to threads of screw (18).
(2)
Position gasket (20), engine lifting bracket (17) and oil filler bracket (19) on cylinder head (13) with
screw (18).
(3)
Apply primer and sealing compound to threads of screw (14).
(4)
Position clip (16), two lockwashers (15) and screws (14) in engine lifting bracket (17).
(5)
Apply primer and sealing compound to threads of screw (18).
(6)
Position screw (18) in cylinder head (13).
(7)
Apply primer and sealing compound to threads of screw (11).
(8)
Position cylinder head support bracket (10) on cylinder head (13) with lockwasher (12) and screw (11).
(9)
Position two washers (9), lockwashers (8) and screws (7) in cylinder head support bracket (10).
(10)
Tighten screw (18) on engine lifting bracket (17) to 23 to 26 lb-ft (31 to 35 N.m).
(11)
Tighten two screws (14) on engine lifting bracket (17) to 41 to 47 lb-ft (56 to 64 N.m).
(12)
Tighten two screws (7) and screw (11) to 35 to 38 lb-ft (47 to 52 N.m).
|
