|
| |
TM 9-2320-364-34-2
3-106
Materials/Parts
Sealing Compound (Item 62, Appendix B)
This task covers:
a. Removal
c. Installation
b. Cleaning/Inspection
d. Follow-On Maintenance
INITIAL SETUP
Personnel Required
Two
Equipment Condition
Flex plate and hub removed, (Para 3-13)
Tools and Special Tools
Tool Kit, General Mechanic’s
(Item 240, Appendix F)
Drill Set, Twist (Item 48, Appendix F)
Drill, Electric, Portable, 1/4 in.
(Item 49, Appendix F)
Expander, Seal, Oil (Item 54, Appendix F)
Expander, Seal, Oil (Item 55, Appendix F)
Goggles, Industrial (Item 83, Appendix F)
Handle, Driver (Item 90, Appendix F)
Handle, Driver (Item 91, Appendix F)
Indicator, Dial, Set w/Magnetic Base
(Item 98, Appendix F)
Installer, Sleeve (Item 120, Appendix F)
3-14. REAR OIL SEAL/SLEEVE REPLACEMENT.
Tools and Special Tools - Continued
Seal Installer, Flywheel (Item 201, Appendix F)
Stone, Abrasive (Item 228, Appendix F)
Stud Set (Item 232, Appendix F)
Washer, 1/4 in. (2)
Screw, Self-Tapping No. 8 by 1 in. (2)
a.
Removal.
Protective goggles must be worn
when drilling holes. Failure to
comply may result in injury to
personnel.
(1)
Drill two 1/8 in. holes directly opposite each
other in seal casing (1).
(2)
Install two washers (2) and self-tapping
screws (3) in drilled holes.
NOTE
Seal is removed by prying against
washers with pry bar.
(3)
Remove and discard seal (1) from flywheel
housing (4).
|
