|
| |
TM 9-2320-364-34-2
3-166
3-29. ENGINE OIL COOLER ASSEMBLY REPLACEMENT (CONT).
Inlet and outlet openings in oil cooler are marked “IN” and “OUT”. Ensure oil cooler is
installed as noted during removal to prevent oil flow from being reversed.
Oil cooler weighs 50 lbs (23 kg). Ensure oil cooler is properly supported upon installation.
Oil cooler contains oil cooler core and gaskets which may fall out and cause damage to
parts if not supported.
(11)
With the aid of an assistant, position oil
cooler (10) on engine (19) and install ten
lockwashers (17) and screws (16) in oil
cooler (10).
(12)
Tighten 12 screws (16) in oil cooler (10) to
10 to 13 lb-ft (14 to 18 N.m).
(13)
Position seal (20) over water outlet (15) and
oil cooler (10).
(14)
Tighten locknut (13) on clamp (14).
(15)
Loosen lower hose clamp (25) so water inlet
housing (12) can be installed.
Adhesives, solvents, and sealing
compounds can burn easily, can
give off harmful vapors, and are
harmful to skin and clothing. To
avoid injury or death, keep away
from open fire and use in well-
ventilated area. If adhesive,
solvent, or sealing compound
gets on skin or clothing, wash
immediately with soap and water.
(16)
Apply sealing compound to four screws (11).
(17)
Install four screws (11) in water inlet
housing (12). Tighten screws to 23 to 26 lb-
ft (31 to 35 N.m).
(18)
Tighten lower hose clamp (25) to 40 lb-in
(5 N.m).
|
