|
| |
TM 9-2320-364-34-2
4-13
b.
Installation.
(1)
Apply lubricating oil to preformed
packings (9).
(2)
Install two preformed packings (9) on
blower (8).
(3)
Install gasket (7) on blower (8).
Use extreme care when installing
air inlet housing on blower.
Failure to comply may result in
serious scratching or denting of
blower.
(4)
Install air inlet housing (6) on blower (8).
(5)
Position ten lockwashers (5) and screws (4)
in air inlet housing (6).
(6)
Tighten screws (4) in sequence shown 40 to
45 lb-ft (54 to 61 N.m).
(7)
Connect MC66 connector (3).
(8)
Install air line 1402 (1) on adapter (2).
c.
Follow-On Maintenance:
Install turbo boost pressure switch,
(TM 9-2320-364-20).
Install turbocharger, (Para 4-8).
Remove wheel chocks, (TM 9-2320-364-10).
END OF TASK
|
