| |
TM 9-2320-364-34-2
4-21
(8)
Position blower (5) over engine (12).
(9)
Install retainer (45) and screw (44) in
blower (5).
(10)
Position seal (46) and clamp (6) on
blower (5).
Ensure driveshaft is pulled from
blower drive support and
wrapped in clean rag from
removal. Failure to comply may
result in damage to equipment.
(11)
Lower blower (5) on engine (12) and
position seal (46) on blower drive
support (4).
(12)
Position two washers (37) and screws (36) in
front end plate (39).
(13)
Install two washers (37) and screw (36) in
rear end plate (38).
|