|
| |
TM 9-2320-364-34-2
4-24
4-4. BLOWER ASSEMBLY REPLACEMENT (CONT).
(27)
Position gasket (21) on flywheel housing
cover (17).
(28)
Position flywheel housing cover (17) on
blower drive support (4).
(29)
Position three lockwashers (19) and
screws (18) in flywheel housing cover (17).
Adhesives, solvents, and sealing
compounds can burn easily, can
give off harmful vapors, and are
harmful to skin and clothing. To
avoid injury or death, keep away
from open fire and use in well-
ventilated area. If adhesive,
solvent, or sealing compound
gets on skin or clothing, wash
immediately with soap and
water.
(30)
Apply sealing compound to two screws
(20).
(31)
Position two screws (20) in flywheel
housing cover (17).
(32)
Position screw (16), lockwasher (15) and
nut (14) in flywheel housing cover (17).
(33)
Tighten six screws (18), (20) and (16) on
flywheel housing cover (17) to 30 to 35
lb-ft (41 to 47 N.m).
(34)
Install fuel hose 3572 (34) to tee (35).
(35)
Install fuel hose 2260 (32) on elbow (33).
(36)
Connect connector (30) on sensor (31).
|
