|
| |
TM 9-2320-364-34-2
5-24
5-6. WATER PUMP ASSEMBLY REPLACEMENT (CONT).
NOTE
If proper backlash cannot be
obtained, do Steps (21)
through (23). If proper backlash
is obtained, go on to Step (24).
(21)
Loosen three water pump screws (15)
and (18) and pivot water pump (5) as
required to obtain proper backlash.
(22)
Tighten two screws (18) to 45 to 50 lb-ft
(61 to 68 N.m).
(23)
Tighten screw (15) to 20 to 25 lb-ft
(27 to 34 N.m).
(24)
Remove screw (29) and dial indicator from
water pump (5).
Use care when installing
retaining rings. Retaining rings
are under tension and can act as
projectiles when released
causing injury to personnel.
(25)
Install preformed packing (28), access
cover (27) and retaining ring (26).
(26)
Strike access cover (26) several times with
soft-faced hammer until fully seated.
c.
Follow-On Maintenance:
Install cab engine access panel,
(TM 9-2320-364-20).
Fill cooling system, (TM 9-2320-364-20).
Remove wheel chocks, (TM 9-2320-364-10).
END OF TASK
|
