|
| |
TM 9-2320-364-34-2
6-29
NOTE
Perform Steps (7) and (8) if
bushing and bearing were
removed.
(7)
Install bushing (45) in end housing (43).
(8)
Install bearing (44) in end housing (43).
(9)
Align matchmarks and install end housing
(43) on alternator housing (40).
Adhesives, solvents, and sealing
compounds can burn easily, can
give off harmful vapors, and are
harmful to skin and clothing. To
avoid injury or death, keep away
from open fire and use in a
well-ventilated area. If adhesive,
solvent, or sealing compound
gets on skin or clothing, wash
immediately with soap and water
(10)
Coat threads of nine studs (42) with sealing
compound.
(11)
Install nine locknuts (41) on studs (42).
Tighten locknuts to 18 lb-in (2 Nm).
(12)
Coat mating surfaces of alternator housing
(40) and heat sink (34) with adhesive.
NOTE
Ensure wires are correctly routed
as noted prior to removal.
(13)
Install heat sink (34) on alternator housing
(40) with lockwasher (39) and screw (38).
Tighten screw to 132 lb-in (15 Nm).
44
45
43
41
40
42
MATCHMARKS
40
34
39
38
|
