|
| |
TM 9-2320-364-34-2
6-73
(2)
Position dial indicator in No. 1 right injector bore (13) and install clamp (14), washer (15) and screw (16)
on injector. Tighten screw to 20 to 25 lb-ft (27 to 34 N.m).
(3)
With the aid of an assistant, turn left camshaft (17) slowly clockwise until large dial hand (18) starts
moving.
(4)
Continue turning left camshaft (17) slowly clockwise until large dial hand (18) stops moving.
If camshaft pulley loosens during procedure, tighten to appropriate torque value. Failure to
comply may result in loose camshaft pulley and possible engine damage may occur.
(5)
Turn left camshaft (17) slowly counterclockwise until large dial hand (18) barely starts to move. Piston is
now at top-dead-center.
|
