|
| |
TM 9-2320-364-34-2
6-142
6-19. CAB WIRE HARNESS REPLACEMENT (CONT).
(6)
Remove locknut (12) and screw (13) from
cab (4) and remove two wires 1435 (14)
and (15), shield wire (16), wire 1435 (17)
and shield wire (18), shield wire (19) and
shield wire (20).
(7)
Position screw (13) and locknut (12) on
bracket (8).
(8)
Disconnect I.D. clearance light 1012
connector (21).
NOTE
Removal of bracket in Step (9) is
for DDEC III engines only.
(9)
Remove two locknuts (22), screws (23) and
MC13 diagnostic connector (24) and
bracket (25) from left side of dash panel
(26). Discard locknuts.
|
