|
| |
TM 9-2320-364-34-2
6-283
NOTE
Apply soap solution to grommets prior to harness installation.
(72)
Position chassis wire harness (15) in cushion clip (67).
(73)
Install screw (68), cushion clip (67), washer (66) and locknut (65) on mud flap (69) and fender (62).
(74)
Position chassis wire harness (15) in three clips (63).
(75)
Install three clips (63) on fender support (64).
(76)
Install grommet (61) on chassis wire harness (15).
(77)
Pull 11 in. of chassis wire harness (15) down through grommet (61).
(78)
Guide chassis wire harness (15) through bottom fender (62). Install grommet (61) on fender (62).
(79)
Install cushion clip (59) on bracket (60) with screw (58) and locknut (57)
Adhesives, solvents, and sealing compounds can burn easily, can give off harmful vapors, and
are harmful to skin and clothing. To avoid injury or death, keep away from open fire and use
in well-ventilated area. If adhesive, solvent, or sealing compound gets on skin or clothing,
wash immediately with soap and water.
(80)
Apply primer and sealing compound to three threads on MC79 connector (55).
(81)
Connect MC79 connector (55) to right side work lamp (56).
|
