|
| |
TM 9-2320-364-34-2
7-3
b.
Installation.
(1)
Install gasket (6), plate (5), solenoid wiring
harness assembly (4) and nine screws (3) on
transmission (7).
NOTE
Perform Steps (2) through (5) if
bulkhead connector was
removed.
(2)
Apply hydraulic oil to preformed
packing (10).
(3)
Install preformed packing (10) on
connector (2).
(4)
Install bulkhead connector (2) in
transmission housing (11).
(5)
Install lockwasher (9) and nut (8) on
connector (2). Tighten to 60 to 68 lb-in
(7 to 8 N.m).
(6)
Connect connector (1) to bulkhead
connector (2).
c.
Follow-On Maintenance:
Install transmission low oil sensor assembly, (Para 7-5).
Remove wheel chocks, (TM 9-2320-364-10).
END OF TASK
|
