|
| |
TM 9-2320-364-34-2
9-51
(30)
Position pivot and spindle assembly (5) to
centered position (parallel to axle).
Adhesives, solvents, and sealing
compounds can burn easily, can
give off harmful vapors, and are
harmful to skin and clothing. To
avoid injury or death, keep away
from open fire and use in well-
ventilated area. If adhesive,
solvent, or sealing compound
gets on skin or clothing, wash
immediately with soap and water.
(31)
Coat mating surface of spindle assembly (5)
with adhesive.
(32)
Install shim (7), thickness determined in Step (24), on steering arm (3).
(33)
Install steering arm (3) on pivot and spindle assembly (5).
(34)
Install four screws (5). Tighten screws to 100 lb-ft (136 N.m).
(35)
Install grease fitting (1) to pivot and spindle assembly (5).
(36)
Rotate pivot and spindle assembly (5) around three times to check for excessive play or force. If incorrect,
repeat Steps (16) through (25).
(37)
Tighten four screws (4) first to 250 lb-ft (339 N.m), then to 500 lb-ft (678 N.m) and then to 720 to 800 lb-ft
(976 to 1085 N.m).
(38)
With torque wrench on screw (4), verify that pivot and spindle assembly (5) requires between 57 to 72 lb-ft
(77 to 98 N.m) to start rotation of the pivot and spindle assembly (5) about its pivot from the center position.
If incorrect, repeat Steps (16) through (34).
c.
Follow-On Maintenance:
Install axle air lines, (TM 9-2320-364-20).
Install tie rod end, (TM 9-2320-364-20).
Install brake assembly, (Para 10-2).
Install self-recovery winch (SRW) rear guide (axle no. 5 only), (TM 9-2320-364-20).
Install wheels/tires, (TM 9-2320-364-10).
Remove wheel chocks, (TM 9-2320-364-10).
END OF TASK
|
