|
| |
TM 9-2320-364-34-2
9-55
(8)
Using inertial extractor, remove two
trunnions (12) from pivot and spindle
assembly (7).
NOTE
Oil seals are removed by tapping
down on one side of oil seal to
work it loose.
(9)
Remove and discard two oil seals (13)
from pivot and spindle assembly (7).
Ensure constant velocity shaft
remains in axle housing when
wheel end is removed. Damage to
bearings inside pivot and spindle
assembly or axle housing may
occur.
(10)
With the aid of an assistant, remove wheel
end assembly (4) from axle housing (14).
(11)
Remove and discard seal (16) and bearing
(17) from wheel end (4).
(12)
Remove constant velocity shaft (15) from
axle housing (14).
Use care when removing retaining
rings. Retaining rings are under
tension and can act as projectiles
when released and could cause
severe eye injury.
(13)
Remove and discard seal (18), and
retaining ring (19) from axle housing (14).
(14)
Using puller, remove and discard bearing
(20) from axle housing (14).
13
13
4
7
12
14
15
12
INERTIAL
EXTRACTOR
LIFTING
DEVICE
20
19
18
15
14
20
PULLER
16
4
17
|
