| |
TM 9-2320-364-34-2
9-60
9-10. AXLE NO. 1, 2 AND 5 INNER AND OUTER AXLE SHAFT SEAL AND
BEARING REPLACEMENT (CONT).
Adhesives, solvents, and sealing
compounds can burn easily, can
give off harmful vapors, and are
harmful to skin and clothing. To
avoid injury or death, keep away
from open fire and use in a well-
ventilated area. If adhesive,
solvent, or sealing compound
gets on skin or clothing, wash
immediately with soap and
water.
(29)
Coat mating surface of steering arm (10) and
pivot and spindle assembly (7) with adhesive.
(30)
Install shim (11), thickness determined in
Step (19), on steering arm (10).
(31)
Install steering arm (10) on pivot and
spindle assembly (7).
(32)
Install four screws (9) on steering arm (10).
Tighten screws to 100 lb-ft (136 N.m).
(33)
Rotate wheel end assembly (4) around three
times to check for excessive play or force. If
incorrect, repeat Steps (10) through (21).
(34)
Tighten four screws (9) on steering arm (10)
first to 250 lb-ft (339 N.m), then to 500 lb-ft
(678 N.m) and then to 750 lb-ft (1017 N.m).
(35)
Remove lifting device from wheel end
assembly (4).
(36)
With torque wrench on screw (9), verify that
wheel end assembly (4) requires between 57
to 72 lb-ft (77 to 98 N.m) to start pivoting of
the wheel end assembly from the centered
position. If incorrect, repeat Steps (15)
through (27).
1
1
2
3
10
11
4
9
7
|