|
| |
TM 9-2320-364-34-2
9-116
9-16. AXLE NO. 2 AND 4 LOCKING CYLINDER REPLACEMENT (CONT).
Adhesives, solvents, and sealing compounds can burn easily, can give off harmful vapors, and
are harmful to skin and clothing. To avoid injury or death, keep away from open fire and use
in well-ventilated area. If adhesive, solvent, or sealing compound gets on skin or clothing,
wash immediately with soap and water.
(9)
Coat mating surface of locking cylinder (6)
with adhesive.
(10)
Position locking cylinder (6) on
differential (10).
(11)
Position plastic washer (9), washer (8) and
screw (7).
NOTE
If a new locking cylinder was
installed or axle differential
was removed, perform Steps
(12) and (14). If the same
locking cylinder was
installed, perform Steps (13)
and (15).
Install screw only to keep
screw hole in locking
cylinder aligned with
differential. Screw should
be installed so that three or
four threads of screw are
engaged.
(12)
Position washer (4) and screw (3) on locking
cylinder (6).
(13)
Position washer (4), shim kit (5) and screw
(3) on locking cylinder (6).
(14)
Tighten screw (7) on locking cylinder (6)
22 to 32 lb-ft (30 to 43 N.m).
(15)
Tighten screws (3) and (7) on locking
cylinder (6) 22 to 32 lb-ft (30 to 43 N.m).
(16)
Install air line 2420 (Axle No. 2) or 2359
(Axle No. 4) (1) to fitting (2).
|
