|
| |
TM 9-2320-364-34-3
15-16
All personnel must stay clear of cab when lifting is in progress. Failure to comply may
result in injury or death to personnel.
(4)
With the aid of an assistant and using lifting device, raise cab (27) up slightly. If cab tilts forward or
backward, lower cab back down.
(5)
Adjust straps to level cab (27).
(6)
Repeat Steps (4) and (5) until cab (27) no longer tilts when lifted.
Ensure air lines and electrical wires do not get tangled with the cab.
(7)
With the aid of an assistant and using lifting device and guide ropes, raise cab (27) onto front and rear
cab mounts (138) and (148).
NOTE
Position locknut only so that it is started on the first three or four threads of screw.
Otherwise installation of front screws will be difficult.
(8)
Position screw (147), washer (146) bracket (144) and locknut (145) on each side of cab (27).
NOTE
Ensure flats on screw are positioned against anti-rotation plate in cab.
(9)
With the aid of an assistant and using lifting device, raise cab slightly and position two screws (137) from
inside of cab (27).
|
