|
| |
TM 9-2320-364-34-3
15-29
Materials/Parts
Locknut (10) (Item 165, Appendix E)
Locknut (Item 167, Appendix E)
Locknut (Item 201, Appendix E)
Locknut (2) (Item 202, Appendix E)
Locknut (9) (Item 210, Appendix E)
Push Clips (3) (Item 457, Appendix E)
Screw, Self-Tapping (2) (Item 557, Appendix E)
This task covers:
a. Removal
b. Installation
c. Follow-On Maintenance
INITIAL SETUP
Personnel Required
Two
Equipment Condition
Engine OFF, (TM 9-2320-364-10)
Wheels chocked, (TM 9-2320-364-10)
Work lamp removed, (TM 9-2320-364-20)
Spare tire carrier and davit removed,
(TM 9-2320-364-20)
Right engine noise panel removed,
(TM 9-2320-364-20)
Hydraulic reservoir removed,
(TM 9-2320-364-20)
Right mud flap removed, (TM 9-2320-364-20)
Right fender front and rear skirt removed,
(TM 9-2320-364-20)
Spare tire carrier winch removed,
(TM 9-2320-364-20)
Rubber fender edging removed,
(TM 9-2320-364-20)
Tools and Special Tools
Tool Kit, General Mechanic’s
(Item 240, Appendix F)
15-4. RIGHT FENDER REPLACEMENT.
NOTE
Push clips are removed by pulling out lock button, then removing clip.
(1)
Remove and discard three push clips (1) from fender support arm (2).
(2)
Remove rubber grommet (3) from fender (4).
(3)
Thread work lamp wiring harness (5) through wiring harness hole (6) and move wiring harness out of way.
|
