|
| |
TM 9-2320-364-34-3
15-28
15-3. WINDSHIELD GLASS REPLACEMENT (CONT).
b.
Installation.
Adhesives, solvents, and sealing compounds can burn easily, can give off harmful vapors, and
are harmful to skin and clothing. To avoid injury or death, keep away from open fire and use
in well-ventilated area. If adhesive, solvent, or sealing compound gets on skin or clothing,
wash immediately with soap and water.
NOTE
If new windshield seal/locking strip is installed, cut two inches longer than original to
insure proper length and perform Steps (1) through (3).
Cut excess windshield seal/locking strip after installation to ensure proper fit.
(1)
Install windshield seal/locking strip (1) in
opening of cab (3).
(2)
Apply primer to ends of windshield
seal/locking strip ends (1).
(3)
Apply adhesive to ends of windshield
seal/locking strip ends (1).
(4)
Coat windshield seal/locking strip (1) with
soapy water.
(5)
With aid of assistant, install windshield (2)
in windshield seal/locking strip (1).
(6)
Engage windshield seal/locking strip (1).
c.
Follow-On Maintenance:
Install gun mount (right side only if equipped), (TM 9-2320-364-20).
Install vehicle weight classification data plate (right side only), (TM 9-2320-364-20).
Install wiper arm assembly (as required), (TM 9-2320-364-20).
Install light bar assembly, (TM 9-2320-364-20).
Remove wheel chocks, (TM 9-2320-364-10).
END OF TASK
|
