|
| |
TM 9-2320-364-34-3
16-48
16-3. BOOM ASSEMBLY REPAIR (CONT).
NOTE
Cable can be held with pliers to
help position in hole.
(112)
Position cable (34) through hole in inner-
mid section (20), swivel nut (33) on cable.
Adhesives, solvents, and sealing
compounds can burn easily, can
give off harmful vapors, and are
harmful to skin and clothing. To
avoid injury or death, keep away
from open fire and use in a well-
ventilated area. If adhesive,
solvent, or sealing compound
gets on skin or clothing, wash
immediately with soap and
water.
NOTE
Ensure grease fittings on sheave pins face rear.
Leverage may need to be applied to cable guide in order to align holes.
(113)
Apply sealing compound to threads of screw (35).
(114)
Align cable guide (38) and inner-mid section (20) and install pin (39), washer (37), lockwasher (36)
and screw (35). Tighten screw to 120 lb-in (14 N.m).
(115)
Pull cable (34) and tighten swivel nut (33) on cable (34).
(116)
Install jam nut (32) on cable (34). Leave 1/4 in. (6.4 mm) of thread exposed.
NOTE
Ensure cable is on sheave side of screw.
(117)
Apply sealing compound to threads of screw (30).
(118)
Install lockwasher (31) and screw (30) on support pin (51). Tighten screw to 120 lb-in (14 N.m).
(119)
Using lifting device, position inner-mid section (20) on opposite side.
|
