|
| |
TM 9-2320-364-34-3
16-81
(10)
Remove two screws (21), washers (22) and
cylinder hold-down (23) from boom
base (11).
NOTE
Perform Step (11) if quick edge
is damaged.
(11)
Remove quick edge (24) from cylinder
hold-down (23).
(12)
Using lifting device, remove telescope
cylinder 96) from boom base (11).
(13)
Repeat Steps (1) through (12) for other
telescope cylinder.
b.
Installation.
Telescope cylinder weighs 70 lbs
(32 kg). Attach suitable lifting
device prior to installation to
prevent possible injury to
personnel.
(1)
Attach lifting device to telescope
cylinder (6).
(2)
With the aid of an assistant, use lifting
device and position telescope cylinder (6) on
boom base (11).
NOTE
Perform Step (3) if quick edge
was removed.
(3)
Install quick edge (24) on cylinder hold-down (23).
Adhesives, solvents, and sealing compounds can burn easily, can give off harmful vapors, and
are harmful to skin and clothing. To avoid injury or death, keep away from open fire and use
in well-ventilated area. If adhesive, solvent, or sealing compound gets on skin or clothing,
wash immediately with soap and water.
(4)
Apply sealing compound on threads of screw (21).
(5)
Install cylinder hold-down (23) on boom base (11) over telescope cylinder (6) with two washers (22) and
screws (21). Tighten screw to 68 lb-ft (92 N.m).
|
