|
| |
TM 9-2320-364-34-3
16-82
16-10. TELESCOPE CYLINDER REPLACEMENT (CONT).
NOTE
Cylinder rod may have to be
repositioned to install retaining
pin.
(6)
Align telescope cylinder (6) in boom base
(11) and install retaining pin (17) and two
cotter pins (18) in telescope cylinder (6).
(7)
Tighten screws (19) on top retaining
plate (20) to 28 lb-ft (38 N.m).
(8)
Remove lifting device from telescoping
cylinder (6).
NOTE
Perform Step (9) if overload
shutdown cable was removed.
(9)
Install washer (16), spacer (15), cable (14)
and screw (13) to retaining pin (17).
Tighten screw to 72 lb-in (8 N.m).
NOTE
Locking hole must be positioned
facing lock pin screw hole.
(10)
Install base end of telescope cylinder (6) on
boom base (11) with pin (12).
Adhesives, solvents, and sealing
compounds can burn easily, can
give off harmful vapors, and are
harmful to skin and clothing. To
avoid injury or death, keep away
from open fire and use in well-
ventilated area. If adhesive,
solvent, or sealing compound
gets on skin or clothing, wash
immediately with soap and
water.
(11)
Apply sealing compound on threads of
screw (7).
(12)
Install lock pin (10), bushing (9), washer (8)
and screw (70 in pin (10) and boom
base (11). Tighten screw to 28 lb-ft
(38 N.m).
|
