|
| |
TM 9-2320-364-34-3
16-105
Do not align notches in stators
and disc. Alignment allows fluid
to flow and will cause incorrect
operation. Start stack with stator.
NOTE
Ensure pressure plates and clutch
discs are installed in same order
as removed.
(13)
Remove cable ties and install seven pressure
plates (14) and eight clutch discs (13) in
hoist brake (3).
(14)
Apply hydraulic oil to preformed
packing (12).
(15)
Install preformed packing (12) and two oil
seals (11) in bearing housing (10).
Adhesives, solvents, and sealing
compounds can burn easily, can
give off harmful vapors, and are
harmful to skin and clothing. To
avoid injury or death, keep away
from open fire and use in well-
ventilated area. If adhesive,
solvent, or sealing compound
gets on skin or clothing, wash
immediately with soap and
water.
(16)
Apply sealing compound on threads of six
screws (8).
(17)
Align matchmarks and install bearing
housing (10) with six washers (9) and
screws (8). Tighten screws to 28 lb-ft
(38 N.m).
|
