|
| |
TM 9-2320-364-34-3
16-263
Use care when installing
retaining rings. Retaining rings
are under tension and can act as
projectiles when released causing
injury to personnel.
NOTE
Coat pin with grease prior to
installation.
(3)
With the aid of an assistant, install two pivot
pins (17), shims (16) and retaining rings
(15) on middle frame (5).
(4)
Block middle frame (5) up in two places so
that front of middle frame is 30 to 35 in.
(76 to 89 cm) above compression frame
where bumpers are mounted.
(5)
Remove lifting device from middle
frame (5).
(6)
Install hoses 2881 (10), 2882 (11), 2891 (12)
and 2892 (13) on middle frame bulkhead
fittings (14).
(7)
Install connector (6) on junction box (7).
(8)
Install cable ties (8) on main harness (9).
|
