|
| |
TM 9-2320-364-34-3
16-269
NOTE
Step (13) applies to tubes on left
side only.
(13)
Remove two screws (20), lockwashers (21)
and proximity switch (22) with clamp. Do
not separate clamp halves.
NOTE
Remove cable ties from tube as required.
(14)
Remove tube nut (23), from bulkhead (24) at inside rear of middle frame (1).
(15)
Pull tube (19) from bulkhead (24), remove preformed packing (25), spacer (26), compression ring (27)
and nut (23), from tube and remove tube from middle frame (1). Discard preformed packing.
b.
Installation.
(1)
Apply hydraulic oil to preformed packing (25).
(2)
Position tube (19) through middle frame (1) and install nut (23), compression ring (27), spacer (26) and
preformed packing (25) on tube (19).
NOTE
Install cable ties as required to secure harness to tube.
(3)
Insert tube (19) into bulkhead (24) and install nut (23) on bulkhead.
|
