|
| |
TM 9-2320-364-34-3
17-29
Adhesives, solvents, and sealing compounds can burn easily, can give off harmful vapors,
and are harmful to skin and clothing. To avoid injury or death, keep away from open fire
and use in well-ventilated area. If adhesive, solvent, or sealing compound gets on skin or
clothing, wash immediately with soap and water.
(7)
Apply sealing compound to threads of four
screws (5).
Universal joint end caps may fall
off performing Steps (8) through
(10).
(8)
Install pump drive shaft (3) on engine (7)
with four screws (5) and lock washers (6).
Tighten screws to 60 lb-ft (81 N.m).
(9)
Apply sealing compound to threads of four
screws (1).
(10)
Install pump drive shaft (3) on yoke (4) with
four screws (1) and two straps (2). Tighten
screws to 25 to 30 lb-ft (34 to 41 N.m).
c.
Follow-On Maintenance:
Fill steering reservoir, (TM 9-2320-364-20).
Fill hydraulic reservoir, (TM 9-2320-364-20).
Start engine and run for three minutes, (TM 9-2320-364-10).
Shut off engine, (TM 9-2320-364-10).
Check for oil leaks, (TM 9-2320-364-10).
Install cab engine access panel, (TM 9-2320-364-20).
Remove wheel chocks, (TM 9-2320-364-10).
END OF TASK
|
