|
| |
TM 9-2320-364-34-3
18-52
Materials/Parts
Cable Ties (Item 9, Appendix B)
Tape, Electrical (Item 74, Appendix B)
This task covers:
a. Installation
b. Follow-On Maintenance
INITIAL SETUP
Personnel Required
Two
Equipment Condition
Engine OFF, (TM 9-2320-364-10)
Wheels chocked, (TM 9-2320-364-10)
Batteries disconnected, (TM 9-2320-364-20)
Right side noise panel removed,
(TM 9-2320-364-20)
Tools and Special Tools
Tool Kit, General Mechanic’s
(Item 240, Appendix F)
18-4. SINCGARS RADIO KIT INSTALLATION.
a.
Installation.
Always disconnect battery
ground cable or power source
before working on electrical
components or injury to
personnel may result. Discharge
capacitors as noted. If personnel
receive an electrical shock, get
immediate medical attention.
NOTE
Retain removed plugs for
future use.
(1)
Remove 15 screws (1), five plugs (2), left
cover (3) and right cover (4) from
Electronic Control Box (ECB) (5).
(2)
Remove plug (6) from ECB (5).
(3)
Install grommet (7) in right side of ECB (5)
and position harness (8) through grommet
(7) into ECB (5).
(4)
Remove locknut (9) from stud (10). Discard
locknut.
(5)
Install wire harness (8) on stud (10) with
locknut (9).
|
