|
| |
TM 9-2320-364-34-3
18-142
18-13. CONTAINER HANDLING UNIT (CHU) KIT INSTALLATION (CONT).
a.
Installation.
Drycleaning Solvent (P-D-680) is TOXIC and flammable. Wear protective goggles, face
shield, and gloves; use only in a well-ventilated area; avoid contact with skin, eyes, and
clothes, and do not breathe vapors. Keep away from heat or flame. Never smoke when
using solvent. The flashpoint for Type II Drycleaning Solvent is 140 degrees F (60 degrees
C) and Type III Drycleaning Solvent is 200 degrees F (93 degrees C). Failure to do so may
result in injury or death to personnel.
If personnel become dizzy while using cleaning solvent, immediately get fresh air and
medical help. If solvent contacts skin or clothes, flush with cold water. If solvent contacts
eyes, immediately flush eyes with water and get immediate medical attention.
NOTE
Container Handling Unit (CHU) can only be installed on PLS M1077 (without crane).
Remove all banding and screws during installation that are supporting components for
packaging and shipping.
A cross-reference of kit parts to kit installation procedures is located in Table 18-1 at the
end of b. Adjustment.
Remove all tags and protection coverings on components and clean bare metal surfaces
with dry cleaning solvent prior to installation.
Adhesives, epoxy, sealants and grease required for kit installation can be found in box A,
pack no. 2 of CHU kit crate.
It may be necessary to unpack boxes as required to locate required box.
|
