|
| |
TM 9-2320-364-34-3
18-163
NOTE
Preformed packings, seals,
thrust washers, shims and
retaining rings can be found
in box C, pack no.
6, 9, 12, 13 and 39 of CHU
kit crate.
Pivot pins are in pack no. 56
of CHU kit crate.
(115)
Install pivot pin (155) and retaining ring
(156) in right rear roller bracket (125).
NOTE
Shim is .06 in. (1.5 mm)
thick. Add one shim per
every gap between retaining
ring and bottom edge of
roller bracket.
Only add shim(s) if gap
between retaining ring and
bottom edge of roller bracket
exceeds .06 in. (1.5 mm).
(116)
Measure distance between retaining ring
(156) and roller bracket (125).
(117)
Determine amount of shims(s) (157)
required and remove retaining ring (156)
and pivot pin (155) from roller bracket
(125).
156
157
155
125
GAP
125
155
156
|
