| |
TM 9-2320-364-34-3
18-174
18-13. CONTAINER HANDLING UNIT (CHU) KIT INSTALLATION (CONT).
(161)
Remove quick release pin (178) and pin
(179) from short strut (168).
NOTE
Stow plate should be
positioned in center of short
strut.
Ensure slider arm is fully
stowed and slider arm handle
contacts long strut prior to
tightening two screws.
(162)
Position short strut (168) on stow plate
(194) in stowed position and that handle
(191) of arm assembly (158) contacts the
long strut (180).
(163)
Tighten two screws (195) and locknuts
(196) on stow plate (194).
(164)
Push down handle (197) and stow right
slider assembly (186) in forward position.
NOTE
Cushion clip can be found in box B,
pack no. 41 and hardware can be
found in box B, pack no. 40 of CHU
kit crate.
(165)
Position three cushion clips (198) on transit
lock switch wire harness (199).
(166)
Position transit lock switch wire harness
(199) along arm assembly (158) and under
right rear roller assembly (125) with
existing wire harnesses towards front of
truck.
Adhesives, solvents, and sealing
compounds can burn easily, can give
off harmful vapors, and are harmful
to skin and clothing. To avoid injury
or death, keep away from open fire
and use in well-ventilated area. If
adhesive, solvent, or sealing
compound gets on skin or clothing,
wash immediately with soap and
water.
(167)
Apply sealing compound (loctite 242) to
threads of three screws (200).
SLIDERS SHOWN
REMOVED FOR
CLARITY
199
200
198
125
186
158
197
179
178
168
196
195
194
191
180
158
198
198
|