|
| |
TM 9-2320-364-34-3
18-211
(52)
With assistant holding arm assembly (158)
out, position flip lock (209) up.
(53)
Measure gap between stop bolt (358) and
right rear roller bracket (125).
NOTE
If gap is not 3/8 in. 1/8 in.
(9.5 mm 3.2 mm), perform
Steps (54) and (55).
If gap is 3/8 in. 1/8 in. (9.5
mm 3.2 mm), go to Step
(57).
(54)
Loosen jam nut (359) and adjust stop bolt
(358) as required.
(55)
Tighten jam nut (359) on stop bolt (358).
NOTE
Longer bolts for flip lock,
2 1/2 in., can be found in
box F, pack no. 70 of CHU
kit crate.
(56)
If proper adjustment could not be made
repeat Steps (52) thru (55) using longer
bolt.
(57)
Align long strut (180) with short strut
(168).
(58)
Using handle of arm assembly (158),
rotate arm assembly out and release flip
lock (209).
(59)
Position long strut (180) into short strut
(168) and install pin (179) and quick
release pin (178).
(60)
Repeat Steps (50) through (59) for left side.
158
125
359
358
209
168
178
179
180
209
158
3/8 IN. 1/8 IN.
(9.5 MM 3.2 MM)
1 1/8 IN. MAX WITH
1 3/4 IN. BOLT
1 5/8 IN. MAX WITH
2 1/2 IN. BOLT
|
