|
| |
TM 9-2320-364-34-3
18-264
18-14. CONVERT DDEC II ENGINE ASSEMBLY TO DDEC III ENGINE ASSEMBLY
(CONT).
NOTE
Left injector wire harness should
be positioned under ECM
bracket.
(172)
Position ECM (222) and ECM bracket
(223) on thermostat housing (235).
(173)
Position turbo boost sensor bracket (37) on
ECM bracket (223) with washer (36),
lockwasher (35) and screw (34). Do not
tighten screw.
(174)
Position washer (26), lockwasher (25) and
screw (236) and ECM bracket (223). Do
not tighten screw.
(175)
Position clip (41), washer (40), lockwasher
(39) and screw (38) on ECM bracket (223).
Do not tighten screw.
(176)
Position clip (33), washer (32), lockwasher
(31) and screw (237) on ECM bracket
(223). Do not tighten screw.
(177)
Position washer (29), lockwasher (28), and
screw (27) on ECM bracket (223). Do not
tighten screw.
Screws connecting bracket to
blower must be tightened first to
prevent damage to housing.
(178)
Tighten two screws (34) and (38) to 120 to
156 lb-in (14 to 18 N.m).
(179)
Tighten three screws (236), (237) and (27)
to 17 to 20 lb-ft (23 to 27 N.m).
(180)
Install two fuel lines (177) and (179) on
fittings (232).
|
