|
| |
TM 9-2320-364-34-4
28-72
28-12. HYDRAULIC MOTOR REPLACEMENT (CONT).
b.
Installation.
Adhesives, solvents, and sealing compounds can burn easily, can give off harmful vapors, and
are harmful to skin and clothing. To avoid injury or death, keep away from open fire and use
in well-ventilated area. If adhesive, solvent, or sealing compound gets on skin or clothing,
wash immediately with soap and water.
Apply adhesive sparingly to hydraulic motor and brake housing. Ensure gasket sealer does not
leak to other parts or damage may result to equipment.
(1)
Apply adhesive to mating surface of
hydraulic motor (4) and brake housing (6).
(2)
Install gasket (5) on hydraulic motor (4).
(3)
Install hydraulic motor (4) on brake
housing (6) with two washers (3),
lockwashers (2) and screws (1). Tighten
screws 75 to 95 lb-ft (102 to 129 N.m).
END OF TASK
|
