|
| |
TM 9-2320-364-34-4
28-81
Materials/Parts
Oil, Hydraulic (Item 34, Appendix B)
Solvent, Drycleaning (Item 68, Appendix B)
Packing, Preformed (3) (Item 395, Appendix E)
Pin, Roll (Item 432, Appendix E)
This task covers:
a. Removal
c. Cleaning/Inspection
e. Installation
b. Disassembly
d. Assembly
f. Follow-On Maintenance
INITIAL SETUP
Equipment Condition
Self-Recovery Winch base mounts removed,
(Para 28-14)
Tools and Special Tools
Tool Kit, General Mechanic’s
(Item 240, Appendix F)
Compressor Unit, Air (Item 35, Appendix F)
Gloves, Chemical Oil Protective
(Item 81, Appendix F)
Goggles, Industrial (Item 83, Appendix F)
Gun, Airblow (Item 86, Appendix F)
Press, 60 Ton (Item 164, Appendix F)
28-15. SELF-RECOVERY WINCH MOTOR END SUPPORT REPAIR.
a.
Removal.
(1)
Remove motor end support (1) from gear
end (2).
NOTE
Roll pin from shifter arm may
fall out when performing
Step (2).
(2)
Position motor end support (1) on level
surface with bearing side up.
NOTE
Perform Step (3) to remove sun
gear primary shaft if not
removed during removal of
motor end support.
(3)
Remove sun gear primary shaft (3) from
gear end (2).
|
